Rooting too soon after an update can lead to a device that does not boot up. It takes a while for the new recovery.img files to make their way to Chainfire who has to then update his files. You do not need to be running that firmware however, you should wait a while if your device has just been updated to a new software update. The following guide to root the Samsung Galaxy S3 running on Android 4.1.2 is based on JZO54K.I9300XXELLC firmware.Click 'Start' and wait for Odin to finish the installation.Īt the end, reboot your device and you should have TWRP 2.5.0.0 installed on your Galaxy S3 I9300.These are the guidelines to root Samsung Galaxy S3 GT-I9300 running Android 4.1.2 Jelly Bean.Click on PDA and add openrecovery-twrp-2.5.0.0-i9300.tar from your PC.Make sure you have "Re-Partition" NOT checked.If you have the drivers installed, Odin should recognize your device and a yellow square should appear in the left upper corner. Press Volume Down + Home + Power simultaneously. Turn off the S3 and connect it to the PC with the USB cable. Go to the folder where you extracted Odin and run the program.Now download openrecovery-twrp-2.5.0.0-i9300.tar from here.Extract the content on your PC in a folder. How to install TWRP 2.5.0.0 on Galaxy S3 I9300: Now you're ready to start installing the recovery.We cannot be held responsible for any damage. Also install USB Drivers for Galaxy S3 on your PC if you haven't already.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |